Leftovers
This is my ebay pile. I hope to make a few bucks off this stuff.
0
Removing the inner plastic mud guard
This thing essentially keeps water and mud from getting all over your battery and electronics. Kinda dumb to remove it but it just looks awful. Plus, I plan on fabricating a custom battery harness and relocating the battery under the seat. The only thing that held this thing on were two tabs on each side. I just pushed the plastic in a little and it fell through the tabs.
Now you can see right to the battery and air filter.
Removing the rear turn signals
I guess I could have taken the grab rail off with the turn signals still attached but I was thinking that I had a better chance at selling the pieces separately on eBay.
I’m not sure if the turn signals were supposed to be held on by bolts or screws. I encountered a screw on on the right turn signal and a bolt on the left signal. Weird, but easy to take off. The last thing I had to do was string the wires through the bolt hole.
Removing the Rear Fender
Removing the seat wasn’t necessary. I just popped open the seat and knocked out the two overhead bolts.
Before I removed the two side bolts I had to disconnect the brake light and turn signal wires from the main wiring harness.
easy
The Honda CB 550
This bike will be the basis for the cafe racer. It is a 1976 Honda CB 550 with only 8000 miles on the engine. The transmission is rock solid and it came with a new set of tires, a new battery, and an inspection sticker valid until 09.
I initially wanted to take the whole thing apart and then put it back together again, but I want to be able to ride it and not have it sit in a thousand pieces for the next two months. So I decided that I’m going to disassemble and reassemble one section at a time.